“The Wham Bam Flexible Build System, addresses the need for printers to have a more reliable build surface which is easy to install and makes printing and removing a breeze. “
Peter Solomon
Wham Bam Systems
APPLICATION & TIPS
No more struggling to pop parts off the build surface.
No more hitting and scraping on your print head and possibly sending it out of alignment.
No more temporary fixes such as glue sticks, hair spray, and painter’s tape.
Easily switch from PEI to PEX surface.
Are you having a difficult time getting your 3D print to stick to your printer bed? Does your print peel up during a long print and destroy your work? Once you get your print to stick, do you have to pry, chisel, cut the perimeter, or put your bed in the freezer, just to get your print off the surface without gouging the surface or cutting yourself?
We have created the specially formulated Wham Bam PEX Polymer Build Surface which surpasses PEI in temperature resistance, performance, and material ‘stickability”. It sticks so well you would have a heck of a time getting the print off the bed without our Wham Bam Flexi Build Plate. Simply remove the Wham Bam Flexi Build Plate from the Wham Bam Flexi Magnetic Base on your 3D printer when the print is finished and flex slightly to pop your print right off! See our demo video below.
HOW TO HANDLE YOUR FBS
Preparation
Prior to installing the FBS, thorougly clean your print bed. Ensure there are no dust deposit.
Installation
As an option, you may heat the print bed at 50 degrees. Stick the magnet using a cloth to remove all trapped bubbles.
Print Surface
Stick the PEX or PEI surface to the Flexi Plate. Each can be installed on either side of the plate.
Leveling
Level the print bed by checking the four corners and its center. If the center is not leveled, add a layer of tape on the magnet (see video below).
MATERIALS
Wham Bam Flexi Build Plates are made from high quality spring steel that won’t kink or warp when you flex them, they just return back to shape! The Spring Steel has been formulated with a Chromium Alloy creating a rust proof steel for long life.
Magnets and films have all been formulated to resist over 150°C so you can heat your bed to high temps for specialty filaments and not worry about loss of performance.
Wham Bam PEX Build Surface have been developed from a specially formulated polymer with a higher melt point than even PEI to attract most any filament without damaging the sheet. Prints easily pop off once cooled and flexed.
HOW TO INSTALL YOUR FBS ON A RESIN PRINTER
WHAM BAM SIZE GUIDE
Is your printer not listed? Please measure your bed (do not rely on build volume) before ordering noting that the spring steel Flexi Plate has two front tabs that stick out by 10mm on smaller kits and 15mm on larger kits.